Well, in this post we are going to tell you how to do window tinting with the best technique and in the fastest way.

First of all, to tint the windows we must clean the car windows well where we are going to support the film to mold it.

Later we will take the measurements of each of the windows and the rear glass and we will proceed to cut them leaving a margin.

We will begin to mold the sheet with a heat gun with a temperature of 300 to 500 degrees, so that it takes the shape of the glass, and once molded, we will cut it to the right size.

It should be noted that to handle the sheet, a sprayer with lime-free water with a soap or neutral liquid is used so that it does not stain the wet parts of the car.

Once the film has been molded and cut, we will proceed to installation. Firstly, we must clean the interior of the glass (where the film will be placed) in such a way that no dirt or particles remain.

Once it has been cleaned, an approval seal is placed between the glass and the sheet, it is installed by removing the protective film while spraying it with the prepared liquid and placing it on the glass on the inside, draining the water with a spatula.

When as much water as possible has been removed, the entire surroundings of the car are cleaned inside and out, and heat is applied to the glass so that it adheres faster and sets in certain areas.

It should be taken into account that you will not be able to lower the car windows for two or three days depending on the time of year, so that the glue finishes taking effect and does not peel off or have imperfections.

Finally, the approval certificate will be delivered, noting the vehicle data such as: license plate, chassis number, vehicle brand, and seal and signature of the authorized installer.

You can see the care to take into account after window tinting for more information.